Re: [CAD_CAM_EDM_DRO] When[emc]Spehro

Any help or thoughts would greatly be appreciated I am new to linux but
a have many years building computers(dos/widozxx).
Thanks Derek B.


Spehro Pefhany wrote:

>
> At 01:47 PM 6/25/00 EDT, you wrote:
> >This is a great idea. I think part of the mission statement for NIST-EMC is
> >to make the technology available for the hobbyist and small-medium size
> >company. The difficulty in setup is a serious barrier - most of the
> >toolmakers I work with are barely making it with Win98, forget about Linux!
> >Would the CD contain a full image of the operating system and maybe a boot
> >disc with a macro to format and partition then copy the CD image to the hard
> >drive. In my humble opinion, RTLinux was more of a pain to set up than
> EMC.
> >If I had more knowledge about Linux, I would contribute, but I'm just
> >reaching the dangerous stage myself (I know just enough to get me into
> >trouble and not enough to get me out of it). Anyway, it's just a thought...
>
> Yes, what would it take to make it as easy to install as RH6.0 or 6.2?
>
> There's some people here developing a Linux distribution, maybe I should
> ask them about it.
>
> Best regards,
>
> =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
> Spehro Pefhany --"it's the network..." "The Journey is the reward"
> speff@... Info for manufacturers: http://www.trexon.com
> Embedded software/hardware/analog Info for designers: http://www.speff.com
> Contributions invited->The AVR-gcc FAQ is at: http://www.bluecollarlinux.com
> =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
>
> ------------------------------------------------------------------------
> Click here for savings: beMANY!
> http://click.egroups.com/1/4115/4/_/423600/_/961955937/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager