Re: [CAD_CAM_EDM_DRO] My ballscrew / bearing block design.

At 06:33 07/11/2005, you wrote:

>I spent the past week or so working on a bearing block design for my
>conversion. I am documenting my project on http://www.cncwright.com
>and I put some screen shots up. I got ballscrews that were only 3/4"
>in diameter and have been trying to figure out a way to mount them in
>bearings bigger then 15mm ID. I am thinking about shrink-fitting an
>adapter on the end of the ballscrew that will also me to make the
>diameter bigger. I'm not too sure about shrink fits and would be
>interested in any tips, information, or alternate ideas.

Alternatively, why not:

- Sleeve the ID of the bearing; or

- Use smaller bearings?


Regards,
Tony