jumpers a Gecko G212
Posted by
odowdpat
on 2005-11-21 11:06:57 UTC
Hello all:
I have a question about how to configure the input header option
on my G212s. I'm using a sound logic breakout board rev. 1.7. My
question is how should I place the jumpers; common ground or common +5
volts? I'm not sure how it should be configured by reading the spec
sheet for the Geckos and/or the sound logic board.
I'd rather ask a dumb question than run the risk of letting the
smoke out of either one. Thank for your help with this.
I have a question about how to configure the input header option
on my G212s. I'm using a sound logic breakout board rev. 1.7. My
question is how should I place the jumpers; common ground or common +5
volts? I'm not sure how it should be configured by reading the spec
sheet for the Geckos and/or the sound logic board.
I'd rather ask a dumb question than run the risk of letting the
smoke out of either one. Thank for your help with this.