Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Posted by
Les Newell
on 2005-11-25 02:36:07 UTC
Hi John,
It is a bit overkill for the job but SheetCam <http://www.sheetcam.com>
will load an Excellon file then output g-code. All you need to tell it
is the cut depth and feed rate. It generates everything else from the
excellon file.
Les
John Dammeyer wrote:
It is a bit overkill for the job but SheetCam <http://www.sheetcam.com>
will load an Excellon file then output g-code. All you need to tell it
is the cut depth and feed rate. It generates everything else from the
excellon file.
Les
John Dammeyer wrote:
>Hi,
>
>Does anyone know of a Excelon to G-Code converter? I found once called
>KCCONV.EXE which runs in a DOS window and is supposed to put out a drill.gc
>file but crashes with a file not found error.
>
>Thanks,
>
>John Dammeyer
>
>
>
>
Discussion Thread
John Dammeyer
2005-11-24 16:16:13 UTC
Excelon to G-Code converter.
Jon Elson
2005-11-24 19:23:45 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Les Newell
2005-11-25 02:36:07 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Zoran A. Scepanovic
2005-11-25 02:48:02 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.