Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Posted by
Zoran A. Scepanovic
on 2005-11-25 02:48:02 UTC
Zdravo John,
Friday, November 25, 2005, 1:13:54 AM, ti rece:
JD> Hi,
JD> Does anyone know of a Excelon to G-Code converter? I found once called
JD> KCCONV.EXE which runs in a DOS window and is supposed to put out a drill.gc
JD> file but crashes with a file not found error.
JD> Thanks,
JD> John Dammeyer
Contact me off-list as I' the author of that converter.
--
Srdacan pozdrav,
����``````````````````````````````````````````````````````����
ZAS ElMed | mailto:zasto@...
szr za proizvodnju i odrzavanje | http://www.zas-elmed.co.yu
medicinske i industrijske |
elektronike i automatike | Tel/Fax: (011) 344-0748
|
Zoran A. Scepanovic | Mob: (063) 609-993
���,������������������������������������������������������,���
*********
Fuzzy project objectives are used to avoid embarrassment of estimating the corresponding costs.
*********
Please be advised what was said may be absolutely wrong, and hereby this disclaimer follows. I reserve the right to be wrong and admit it in front of the entire world.
[Non-text portions of this message have been removed]
Friday, November 25, 2005, 1:13:54 AM, ti rece:
JD> Hi,
JD> Does anyone know of a Excelon to G-Code converter? I found once called
JD> KCCONV.EXE which runs in a DOS window and is supposed to put out a drill.gc
JD> file but crashes with a file not found error.
JD> Thanks,
JD> John Dammeyer
Contact me off-list as I' the author of that converter.
--
Srdacan pozdrav,
����``````````````````````````````````````````````````````����
ZAS ElMed | mailto:zasto@...
szr za proizvodnju i odrzavanje | http://www.zas-elmed.co.yu
medicinske i industrijske |
elektronike i automatike | Tel/Fax: (011) 344-0748
|
Zoran A. Scepanovic | Mob: (063) 609-993
���,������������������������������������������������������,���
*********
Fuzzy project objectives are used to avoid embarrassment of estimating the corresponding costs.
*********
Please be advised what was said may be absolutely wrong, and hereby this disclaimer follows. I reserve the right to be wrong and admit it in front of the entire world.
[Non-text portions of this message have been removed]
Discussion Thread
John Dammeyer
2005-11-24 16:16:13 UTC
Excelon to G-Code converter.
Jon Elson
2005-11-24 19:23:45 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Les Newell
2005-11-25 02:36:07 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.
Zoran A. Scepanovic
2005-11-25 02:48:02 UTC
Re: [CAD_CAM_EDM_DRO] Excelon to G-Code converter.