Re: Acceleration rates..
Posted by
turbulatordude
on 2005-11-28 12:17:57 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "leslie watts" <leswatts@a...>
wrote:
the corner and do a circle and hit if from the perpendicular. it
would waste material, but offer a sharp corner.
Dave
wrote:
>corner
> Just a few words on acceleration rates...a different perpective...
>
> Consider when you want to pass through a corner without stopping.
> That corner will be rounded to a particular radius, and that radius
> will be the square of the end effector speed divided by the accel.
>
> An example might be a cnc router going at a path rate of 4 inches per
> second.
> Let's say you have available 0.1g. That is about 38 inches /sec^2.
>
> The minimum radius at that speed is simply 4*4/38=0.42 in!
>
> At 1 inch per second speed the radius would be 1*1/38= 0.026 in.
>
> Obviously you need to slow down in sharp corners, but there is a limit
> to that depending on chip load and burning.
>
> Take the lowest speed you can cut without burning and the sharpest
> you need to do. The accel required is that speed squared divided by theI thought about the sharp corner thing and had the idea one could pass
> radius.
>
> Les
the corner and do a circle and hit if from the perpendicular. it
would waste material, but offer a sharp corner.
Dave
Discussion Thread
Jarrett & Heidi Johnson
2005-11-24 16:31:07 UTC
Re: Acceleration rates..
Les Newell
2005-11-25 02:30:00 UTC
Re: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
Heidi Johnson
2005-11-25 07:02:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
Brad Eyben
2005-11-27 08:52:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
Jarrett & Heidi Johnson
2005-11-27 21:27:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
leslie watts
2005-11-28 05:42:35 UTC
RE: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
turbulatordude
2005-11-28 12:17:57 UTC
Re: Acceleration rates..
Stephen Wille Padnos
2005-11-28 12:20:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Acceleration rates..
leslie watts
2005-11-28 15:55:07 UTC
RE: [CAD_CAM_EDM_DRO] Re: Acceleration rates..