Re: [CAD_CAM_EDM_DRO] Linux red hat 5.2

John,

Thanks, I have an extra AMD586 computer that I may load it on. Bill
Scalione who is also on the list and lives her in Euless Texas can give me
some help. He has EMC running.

I should have my new cnc router completed in the morning. I would like to
test it with EMC after I test it with the CNC Controller from Microsystems.
I also have a copy of CNCPro and an old version of ahha. I also plan to get
a copy of FlashCut and their drivers.

Bob Campbell

----- Original Message -----
From: Jon Elson <jmelson@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, June 26, 2000 11:41 PM
Subject: Re: [CAD_CAM_EDM_DRO] Linux red hat 5.2


>
>
> Bob Campbell wrote:
>
> > John,
> >
> > Is Red Hat version 5.2 the version that most of you are working with?
>
> I am using Red Hat 5.2, with the 2.0.36 kernel. It is updated with
> RT0.9J and
> I'm running the 20-Dec-1999 version of EMC.
>
> Jon
>
>
> ------------------------------------------------------------------------
> Accurate impartial advice on everything from laptops to table saws.
> http://click.egroups.com/1/4634/4/_/423600/_/962122243/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager