Anyone know of a MHP S-0?
Posted by
jerrybiehler
on 2005-12-02 23:22:12 UTC
At one of the places I repair equipment for they have a MHP S-0that they have offered to sell
to me for about $1000. Set up for 220c 3phase. comes with some tooling. Servo amps have
been refurbed. A couple new boards in the Hydropath III control. The problem with it? It
works, but when they ramp up the speed, the spindle shuts down. Sounds like it couldnt be
to big of a problem, but I could be wrong. Is it worth $1000? I kinda thik so. If nothing else,
use a PC with a servo2go card and add a vfd?
-Jerry
to me for about $1000. Set up for 220c 3phase. comes with some tooling. Servo amps have
been refurbed. A couple new boards in the Hydropath III control. The problem with it? It
works, but when they ramp up the speed, the spindle shuts down. Sounds like it couldnt be
to big of a problem, but I could be wrong. Is it worth $1000? I kinda thik so. If nothing else,
use a PC with a servo2go card and add a vfd?
-Jerry