GUUT
Posted by
Doug
on 2006-01-03 09:09:29 UTC
Greetings everyone!
Ballendo from the DIY-CNC pointed me over here and said I should ask you all about a
"GUUT"??? I've tried a search of the archives, but wow! it is huge and the search is going very
slowly. Can anyone point me there more quickly?
Anyway, I've come across some old stepper motors and Ballendo was kind enough to give me
some ideas on how to make them spin. Probably not much of an achievement in the world of
CNC, but this would be a huge step for me. Typical teacher type, he's told me how to find
which wire is which, and how to wire up some switches, but he's leaving the discovery of how
to make the motors rotate up to me.
Thanks in advance,
Doug
Portland, OR
Ballendo from the DIY-CNC pointed me over here and said I should ask you all about a
"GUUT"??? I've tried a search of the archives, but wow! it is huge and the search is going very
slowly. Can anyone point me there more quickly?
Anyway, I've come across some old stepper motors and Ballendo was kind enough to give me
some ideas on how to make them spin. Probably not much of an achievement in the world of
CNC, but this would be a huge step for me. Typical teacher type, he's told me how to find
which wire is which, and how to wire up some switches, but he's leaving the discovery of how
to make the motors rotate up to me.
Thanks in advance,
Doug
Portland, OR
Discussion Thread
Doug
2006-01-03 09:09:29 UTC
GUUT
Andy Wander
2006-01-10 06:45:53 UTC
RE: [CAD_CAM_EDM_DRO] GUUT
T.Bare
2006-01-10 17:34:46 UTC
RE: [CAD_CAM_EDM_DRO] GUUT