Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Posted by
Jarrett & Heidi Johnson
on 2006-01-08 21:46:06 UTC
Bob, I got reading your white page about power
supplies and what not that you sent me a link for.
In it you state that you used a Plitron Toroid
transformer # 077015201 This unit is rated at 22V
and 6.28A, however in your text you noted that it
will produce 13.26A [ ish] so.. I'm wondering if
it had two leads which you could connect to double
the current? If so.. then spec'ing a Toroid from
them just got a whole lot easier.
Thanks!
Jarrett
supplies and what not that you sent me a link for.
In it you state that you used a Plitron Toroid
transformer # 077015201 This unit is rated at 22V
and 6.28A, however in your text you noted that it
will produce 13.26A [ ish] so.. I'm wondering if
it had two leads which you could connect to double
the current? If so.. then spec'ing a Toroid from
them just got a whole lot easier.
Thanks!
Jarrett
> Jarrett,
>
> You do not need 25 times. I would go with a 48
> VAC transformer which would
> give you about 67 volts DC.
>
> Your Gecko drives will not draw the full 24
> amps. You need to derate it by a
> factor of about .6 which brings it down to about
> 16 amps.
>
> I would go with one 18,000 mfd capacitor.
>
> Bob Campbell
> Bob Campbell Designs
> www.Campbelldesigns.com
> Mach 2/3 breakout boards
> Relay boards
> Spindle Speed boards
> Stepper motors
> Plasma Torch Height control
Discussion Thread
Jarrett & Heidi Johnson
2006-01-03 22:47:18 UTC
Re: Power Supply-- more questions
Anders Wallin
2006-01-04 01:42:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Robert Campbell
2006-01-04 07:20:51 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Roy J. Tellason
2006-01-04 09:10:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
JanRwl@A...
2006-01-04 17:55:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Jon Elson
2006-01-04 21:03:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Jarrett & Heidi Johnson
2006-01-08 21:46:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
Robert Campbell
2006-01-09 07:42:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Power Supply-- more questions
jerryflyguy
2006-01-09 12:16:28 UTC
Re: Power Supply-- more questions