Re: [CAD_CAM_EDM_DRO] Re: Safe Spindle Control

In a message dated 1/18/2006 12:09:05 PM Mountain Standard Time,
jeff@... writes:

My coil
is wired to a normally open contact of my ENABLE relay. This in turn cannot
be actuated until MACH is activated. It's sort of a failsafe. If the
software isn't running, nothing works. If the software is running, an
E-Stop kills all moving motors. Independently, I can turn the spindle
on/off, but only if the other conditions are met.



Jeff, How about considering posting a schematic of your control system in
the files, or sending it to Tim for the inclusion in the FAQ.

For others that have not visited the FAQ, I would hope that you will take a
look soon..................
bill


[Non-text portions of this message have been removed]