CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations

Posted by Vlad Krupin
on 2006-01-23 16:33:13 UTC
On 1/23/06, Phil Mattison <mattison20@...> wrote:
[snip]

> I would think
> that the motor current ratings are for holding current, and could be
> substantially exceeded when stepping at high speed without damaging the
> motor, since heat dissipation is the main reason for current limitation.


It is, indeed the main limitation. Out of curiosity I did some searching and
came up with this table: http://www.kjmagnetics.com/specs.asp

Those are some seriously low temperatures! It shows that it does not take
much heat to permanently damage a neodymium magnet. Depending on the motor
design, I think, the magnets may have a hard time transferring heat to the
body of the motor. You may not even realize that your motor is at risk until
it is too late.

(probably 99% of you knew that already, but just how low the safe operating
temperature can be was news to me. So I figured I'd share what I found and
maybe save somebody a bit of extra grief)

Vlad

[snip]

--
Vlad's shop
http://www.krupin.net/serendipity/index.php?/categories/2-metalworking


[Non-text portions of this message have been removed]

Discussion Thread

Phil Mattison 2006-01-22 12:01:51 UTC Stepper Motor Power Calculations caudlet 2006-01-22 13:54:49 UTC Re: Stepper Motor Power Calculations JanRwl@A... 2006-01-22 23:41:23 UTC Re: [CAD_CAM_EDM_DRO] Stepper Motor Power Calculations Phil Mattison 2006-01-23 07:53:09 UTC [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations caudlet 2006-01-23 09:08:24 UTC Re: Stepper Motor Power Calculations Phil Mattison 2006-01-23 16:13:08 UTC [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations Vlad Krupin 2006-01-23 16:33:13 UTC Re: [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations Phil Mattison 2006-01-23 17:43:51 UTC [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations Mariss Freimanis 2006-01-23 19:20:05 UTC Re: Stepper Motor Power Calculations Phil Mattison 2006-01-24 09:10:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Stepper Motor Power Calculations Mariss Freimanis 2006-01-24 11:53:55 UTC Re: Stepper Motor Power Calculations