Re: milling spindle on a CNC router
Posted by
jfglass2001
on 2006-02-19 12:40:38 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dayap1" <dayap@...> wrote:
you use a speed controller like that. And you're correct, there is
very little torque...
>controller
> If it uses a Fixed speed router, you can get a router speed
> from many sources (Woodcraft, Harborfreight) that will slow downthe
> router.very
> Of course, the torque will be quite low, so you will need to tale
> light cuts.<jfglass2001@>
>
> Regards.
> Daya.
>
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "jfglass2001"
> wrote:From what I understand though, it tends to wear out the router when
you use a speed controller like that. And you're correct, there is
very little torque...
Discussion Thread
jfglass2001
2006-02-15 03:28:07 UTC
milling spindle on a CNC router
dayap1
2006-02-19 11:55:35 UTC
Re: milling spindle on a CNC router
jfglass2001
2006-02-19 12:40:38 UTC
Re: milling spindle on a CNC router
Dave Halliday
2006-02-19 13:51:23 UTC
RE: [CAD_CAM_EDM_DRO] Re: milling spindle on a CNC router