Re: Lathe C ProAMgram
Posted by
wanliker@a...
on 2006-03-10 21:41:06 UTC
In a message dated 3/10/2006 9:52:19 PM Mountain Standard Time, WAnliker
writes:
In a message dated 2/28/2006 12:38:06 PM Mountain Standard Time,
SherlineCNC@yahoogroups.com writes:
Message: 4
Date: Mon, 27 Feb 2006 13:49:33 -0700
From: "Phil Mattison" <mattison20@...>
Subject: Re: lathe CAM program
There are some handy utilities at http://www.ohmikron.com/
under the G-Code Tools menu.
From the Sherline CNC group, check it out......................
bill
There is a very good paper on G-Codes with explanations, and of course
several lathe G-Code Wizards that with a few inputs make's a G-Code for you. Plus
a lot of other stuff, that you will most likely find interesting.
bill
[Non-text portions of this message have been removed]
writes:
In a message dated 2/28/2006 12:38:06 PM Mountain Standard Time,
SherlineCNC@yahoogroups.com writes:
Message: 4
Date: Mon, 27 Feb 2006 13:49:33 -0700
From: "Phil Mattison" <mattison20@...>
Subject: Re: lathe CAM program
There are some handy utilities at http://www.ohmikron.com/
under the G-Code Tools menu.
From the Sherline CNC group, check it out......................
bill
There is a very good paper on G-Codes with explanations, and of course
several lathe G-Code Wizards that with a few inputs make's a G-Code for you. Plus
a lot of other stuff, that you will most likely find interesting.
bill
[Non-text portions of this message have been removed]