Re: [CAD_CAM_EDM_DRO] Cam for UnderCut Mach.
Posted by
Les Newell
on 2006-03-25 01:32:53 UTC
Does MasterCam allow you to use leadins and leadouts? If you use a big
enough leadin and leadout the cutter will plunge next to the edge then
move into the undercut.
Les
shadi_salhab_78 wrote:
enough leadin and leadout the cutter will plunge next to the edge then
move into the undercut.
Les
shadi_salhab_78 wrote:
> Hi all ,
> I 'am trying to machine an undercut using lollipop milling tool, I'am
> using MasterCam v9 but could not do it !
>
> Any ideas ?
>
Discussion Thread
shadi_salhab_78
2006-03-24 20:47:28 UTC
Cam for UnderCut Mach.
Les Newell
2006-03-25 01:32:53 UTC
Re: [CAD_CAM_EDM_DRO] Cam for UnderCut Mach.
Michael Milligan
2006-03-25 03:06:57 UTC
RE: [CAD_CAM_EDM_DRO] Cam for UnderCut Mach.