CAD CAM EDM DRO - Yahoo Group Archive

Post Processor Questions

Posted by wanliker@a...
on 2006-04-01 11:18:36 UTC
I am playing with both Dolphin, and Vector, for CAD/CAM, and with TurboCNC,
and Mach3.. (alphabetical order)

Machines are Sherline, Lathe and Mill for now.

Questions:
Are post processors required with any of these combinations?

Dolphin.... and Mach? TurboCNC?
Vector......and Mach? TurboCNC?
(alphabetical order)

If required, are they available, Where can I find them?

Thank You,
bill


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2006-04-01 11:18:36 UTC Post Processor Questions John Stevenson 2006-04-01 12:11:38 UTC Re: Post Processor Questions wanliker@a... 2006-04-01 12:16:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Post Processor Questions wanliker@a... 2006-04-01 15:59:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Post Processor Questions