CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Post Processor Questions

Posted by wanliker@a...
on 2006-04-01 15:59:07 UTC
In a message dated 4/1/2006 1:17:23 PM Mountain Standard Time,
wanliker@... writes:

and a mill post for TurbCNC



Will the post for Lathe in TurboCNC be the same?

This is not for the Sherline system that they sell.
Thanks,
bill

Joined that group membership is pending.


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2006-04-01 11:18:36 UTC Post Processor Questions John Stevenson 2006-04-01 12:11:38 UTC Re: Post Processor Questions wanliker@a... 2006-04-01 12:16:47 UTC Re: [CAD_CAM_EDM_DRO] Re: Post Processor Questions wanliker@a... 2006-04-01 15:59:07 UTC Re: [CAD_CAM_EDM_DRO] Re: Post Processor Questions