STG2
Posted by
johndroc@a...
on 2000-07-07 09:31:05 UTC
As you may have figured out, I'm working on a CNC - EMC retrofit. To date, I
have not been able to get the Y axis running. I've narrowed it down to
either the STG2 card or EMC and eliminated the machine/amps/etc. I've also
conditionally eliminated the STG2 board, in that I can manually set voltages
on it, using the diagnostic software. Has anyone successfully run an STG
Model 2 - 4 or 8 axis?
-John
have not been able to get the Y axis running. I've narrowed it down to
either the STG2 card or EMC and eliminated the machine/amps/etc. I've also
conditionally eliminated the STG2 board, in that I can manually set voltages
on it, using the diagnostic software. Has anyone successfully run an STG
Model 2 - 4 or 8 axis?
-John