Re: [CAD_CAM_EDM_DRO] STG2
Posted by
Darrell
on 2000-07-07 09:40:08 UTC
While I have not used the STG card, I do remember that the STG 2 uses
different files in EMC than the STG card. Are you using the correct files
for your card?
Darrell
different files in EMC than the STG card. Are you using the correct files
for your card?
Darrell
----- Original Message -----
From: <johndroc@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Friday, July 07, 2000 9:30 AM
Subject: [CAD_CAM_EDM_DRO] STG2
> As you may have figured out, I'm working on a CNC - EMC retrofit. To
date, I
> have not been able to get the Y axis running. I've narrowed it down to
> either the STG2 card or EMC and eliminated the machine/amps/etc. I've
also
> conditionally eliminated the STG2 board, in that I can manually set
voltages
> on it, using the diagnostic software. Has anyone successfully run an STG
> Model 2 - 4 or 8 axis?
>
> -John
>
> ------------------------------------------------------------------------
> Missing old school friends? Find them here:
> http://click.egroups.com/1/5534/4/_/423600/_/962987466/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
Discussion Thread
Darrell
2000-07-07 09:40:08 UTC
Re: [CAD_CAM_EDM_DRO] STG2
johndroc@a...
2000-07-07 09:50:07 UTC
Re: [CAD_CAM_EDM_DRO] STG2
Jon Elson
2000-07-07 12:18:16 UTC
Re: [CAD_CAM_EDM_DRO] STG2
johndroc@a...
2000-07-07 13:27:49 UTC
Re: [CAD_CAM_EDM_DRO] STG2
Doug Yeager
2000-07-07 16:06:06 UTC
cncpro and ACEconverter on ebay