Re: [CAD_CAM_EDM_DRO] Linux & LS120 drives

Wayne
Thanks for your response.
I will be using and IDE LS 120. I hoping it would be supported by 5.2
It is a good way to move data between computers when you don't have a
network hooked up. I have ordered the CD with RH 5.2 and ECM from Tim
Goldstein.
Jim

----- Original Message -----
From: Wayde Gutman <wcgutman@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Saturday, July 08, 2000 10:08 PM
Subject: Re: [CAD_CAM_EDM_DRO] Linux & LS120 drives


> It should be supported under the most recent kernel releases, as
used
> under Red Hat 6.2 for example. However, if you have a parallel
ported
> LS-120 drive, you will have to hand hack the parport device support.
I
> had it working, for a while, under Caldera OpenLinux 2.3, but forgot
how
> I did it.
>
> James Cullins wrote:
>
> > Does anyone know if you can use Linux with
> > an LS120 drive?
> > Jim
> >
>
> --------------------------------------------------------------------
---
> >
>
> --------------------------------------------------------------------
---
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> > discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> >
> > Addresses:
> > Post message: CAD_CAM_EDM_DRO@egroups.com
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> > Moderator: jmelson@... [Moderator]
> > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > FAQ: http://www.ktmarketing.com/faq.html
> > bill,
> > List Manager
>
>
>
>
> [Non-text portions of this message have been removed]
>
>
> --------------------------------------------------------------------
----
> Life's too short to send boring email. Let SuperSig come to the
rescue.
> http://click.egroups.com/1/6137/4/_/423600/_/963111961/
> --------------------------------------------------------------------
----
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>