RE: [CAD_CAM_EDM_DRO] Re: EMC easy install CDROM

That machine would work far better, but you could certainly pull out a lot
of ram and use it where it is needed. If you are just running Linux as a
machine controller with EMC you can get by with 16 mb if you don't open much
of anything else at the same time and 32 mb is plenty. Now if you want to
use the machine for more than a machine controller then I would use 64 mb.

Tim
[Denver, CO]

> Tanks for the info, I gues I could load Windoze on the P 100 and use
> my K6 450 / 128 Megs ram for it. I will look at the versions of linux
> I have.
>
> > I run it on an AMD K6 500 and it is great. If you use the open loop
> > steppermot your system will work just great until you start trying
> for rapid
> > rates that cause the unevenly spaced pulses from steppermot to give
> you
> > stalls.
>