Re: [CAD_CAM_EDM_DRO] Dan,tell us about the EDM
Posted by
Dan Mauch
on 2000-07-11 19:18:49 UTC
That is correct. I have having problems with Backpage 98 so hopefully the
pictures will we up then. I think you will be impressed.
Dan
-----Original Message-----
From: Carey L. Culpepper <mr.c@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, July 11, 2000 7:13 PM
Subject: [CAD_CAM_EDM_DRO] Dan,tell us about the EDM
pictures will we up then. I think you will be impressed.
Dan
-----Original Message-----
From: Carey L. Culpepper <mr.c@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, July 11, 2000 7:13 PM
Subject: [CAD_CAM_EDM_DRO] Dan,tell us about the EDM
>I was just over at the Camtronics site snooping around and noticed thatdiscussion of shop built systems, for CAD, CAM, EDM, and DRO.
>there is a new addition. Plans for a sinker EDM.The photos that were
>supposed to be there weren't so I assume Dan is working on that now. The
>new addition was dated today,so it is hot off the presses.
>Carey
>
>
>------------------------------------------------------------------------
>Get a NextCard Visa, in 30 seconds!
>1. Fill in the brief application
>2. Receive approval decision within 30 seconds
>3. Get rates as low as 2.9% Intro or 9.9% Fixed APR
>http://click.egroups.com/1/6631/4/_/423600/_/963367996/
>------------------------------------------------------------------------
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>