Re: Need Source for Large Servo Motors
Posted by
vrsculptor
on 2006-08-23 19:12:44 UTC
Jon
I don't disagree with your statement on positioning however If you
look at the red footnote on on <www.kelinginc.net/DCBrushMotor.html>
you will see that Gecko is offering a modified G320. If Marriss says
its OK its good enough for me. I have, as they say, no dog in this
fight.
Roger
I don't disagree with your statement on positioning however If you
look at the red footnote on on <www.kelinginc.net/DCBrushMotor.html>
you will see that Gecko is offering a modified G320. If Marriss says
its OK its good enough for me. I have, as they say, no dog in this
fight.
Roger
> ON> You should note that Mariss of Gecko Drives had to modify hisG320 drive
> to run Keling's motorselling the
> without excessive torque and velocity ripple. Gecko is not
> modified servo drive yet.there
> I don't know if they will sell a special model. In other words,
> motors were not really
> made for positioning servo work.
>
> Jon
>
Discussion Thread
danieltmedlin
2006-08-22 17:41:35 UTC
Need Source for Large Servo Motors
KelingInc
2006-08-23 09:46:38 UTC
Re: [CAD_CAM_EDM_DRO] Need Source for Large Servo Motors
Jon Elson
2006-08-23 18:53:46 UTC
Re: [CAD_CAM_EDM_DRO] Need Source for Large Servo Motors
vrsculptor
2006-08-23 19:12:44 UTC
Re: Need Source for Large Servo Motors
Les Newell
2006-08-24 01:20:19 UTC
Re: [CAD_CAM_EDM_DRO] Need Source for Large Servo Motors
Jon Elson
2006-08-24 09:07:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Need Source for Large Servo Motors
Jon Elson
2006-08-24 09:18:34 UTC
Re: [CAD_CAM_EDM_DRO] Need Source for Large Servo Motors