Re: [CAD_CAM_EDM_DRO] mouse as a dro?(stupid idea?)

Jim,

You will find the Lindsay software (free) at:
http://www.metalworking.com/shareware.html

Steve's url:
http://www.nyx.net/~slindsay/dro.html

Electronic Goldmine url:
http://www.goldmine-elec.com/

The motor/encoders you want are item# G9933. $3.95 in my last catalog.

Bob

At 06:15 PM 7/12/00 -0500, you wrote:

>Bob
> Does Steve Lindsay have a URL and what is Electronics Goldmines
>URL?
>Jim
>----- Original Message -----
>From: Robert Bachman <bobach@...>
>To: <CAD_CAM_EDM_DRO@egroups.com>
>Sent: Wednesday, July 12, 2000 8:38 AM
>Subject: Re: [CAD_CAM_EDM_DRO] mouse as a dro?(stupid idea?)
>
>
>> I fooled around with the mouse dro too. The resolution is just too
>> coarse to be of any real use.
>>
>> Buy 2 or 3 of the motors/encoders from Eletronics Goldmine and
>> build Steve Lindsay's or Dan Mauch's interface. Lindsay's setup
>> can be put together for under $30 including encoders.
>>
>> Bob
>>
>>
>>
>>
>> --------------------------------------------------------------------
>----
>> Experience MSN...
>> Get 1 FREE* month of unlimited Internet access!
>> http://click.egroups.com/1/6323/4/_/423600/_/963408928/
>> --------------------------------------------------------------------
>----
>>
>> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
>discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>>
>> Addresses:
>> Post message: CAD_CAM_EDM_DRO@egroups.com
>> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>> Moderator: jmelson@... [Moderator]
>> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>> FAQ: http://www.ktmarketing.com/faq.html
>> bill,
>> List Manager
>>
>>
>
>
>------------------------------------------------------------------------
>Your old buddies are not out of range anymore. Free search with
>Military.com's Personnel Locator.
>http://click.egroups.com/1/4158/4/_/423600/_/963443227/
>------------------------------------------------------------------------
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>