CAD CAM EDM DRO - Yahoo Group Archive

Re: nice servos from plotter

Posted by skykotech
on 2006-09-01 12:04:40 UTC
No, I didn't have any problems with the encoder wiring. The ground
pin was easy to find as it was connected to the ground plane and
thus all the mounting screws. I guessed that power would be +5
volts, and since there was a pin with a larger trace which was
routed to several chips, I assumed that to be power. I guessed on
channel A and channel B, and of course got them wrong :-) but that
hurts nothing..just swap them.

The motor is DC and only has 2 power wires, red and black. Bog
simple!

What does the 4699A look like? Is it a A size or one of the large D
or E size?



> Rick:
>
> I have a 4699A hp plotter that doesn't work, that somebody trash-
picked
> and gave to me. I want to start fooling around with it and see if
I can
> make something useful out of it.
>
> Did you have any problems deciphering the wiring to the encoders
and the
> motors?(I assume the motors are just 2 wires, and the encoders
are....?)
>

Discussion Thread

skykotech 2006-08-31 19:14:34 UTC nice servos from plotter BRIAN FOLEY 2006-08-31 19:42:15 UTC Re: [CAD_CAM_EDM_DRO] nice servos from plotter roboticscnc 2006-09-01 03:51:56 UTC Re: nice servos from plotter skykotech 2006-09-01 07:42:43 UTC Re: nice servos from plotter Andy Wander 2006-09-01 11:31:06 UTC RE: [CAD_CAM_EDM_DRO] nice servos from plotter skykotech 2006-09-01 12:04:40 UTC Re: nice servos from plotter Andy Wander 2006-09-01 12:26:20 UTC RE: [CAD_CAM_EDM_DRO] Re: nice servos from plotter Dennis Schmitz 2006-09-01 13:15:11 UTC Re: nice servos from plotter Dennis Schmitz 2006-09-01 13:21:07 UTC Re: nice servos from plotter turbulatordude 2006-09-01 18:26:57 UTC Re: nice servos from plotter