Re: [CAD_CAM_EDM_DRO] Re: WHO CAN I CHANGE A SIGNAL

In a message dated 10/26/2006 8:45:12 P.M. Eastern Daylight Time,
liosnava@... writes:

THANKS Randy

IT IS WELL BUT I TRY TO MAKE THE CIRQUIT AND THIS DON'T WORK
MEAYBE THIS COMPONENT WORK

STAY IN CONTACT



I also built my own converter circuit using op amps but it just wasn't good
enough. I ended up purchasing boards from another company before I found
Rutex. I paid almost $400.00 USD each for the boards. The Rutex products are
smaller, and much lower in cost, plus they are great quality. I think that is
the way for you to go. Let me know if I can help in any way.


Randy Abernathy
4626 Old Stilesboro Road NW
Acworth, GA 30101-4066
E-mail: cnc002@...

I furnish technical support, repair, and other related services for your
industrial woodworking machinery. My background as Senior Service Engineer for
the SCMI Group for nearly fifteen years with factory training, combines with
my extensive background in electronics, mechanics, pneumatics, electrical and
CNC machinery to offer you needed support for your machinery. Services
include but are not limited to the following:


[Non-text portions of this message have been removed]