CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] RE Missing Posts A missing but traceable post

on 2000-07-14 20:01:33 UTC
drspiff@... wrote:
>
> Howdy All! I'm a little curious about these missing messages. I posted
> a message on 09-JUL-00 about drivers for my Bridgeport and was a
> little concerned that there were NO responses. Then it dawned on me
> that I didn't get that message from the group either. But it is in the
> list of messages.
>
> So does anybody recall seeing the following post?
>
> Message #8795 Subject: New drivers for Bridgeport steppers
> by Rick Dulas <drspiff@...> on Sun Jul 9, 2000 3:01am
>
> If not, then we certainly have a traceable posting for egroup to
> follow up on.
>
> Just curious,
>
> Rick
>


Rick;

Just checked my system and found only one post from you. That was
on Jul 08 and the subject was Re: [CAD_CAM_EDM_DRO] stepper drives and
motor size.

nothing with the above subject line.

Bill

Discussion Thread

wanliker@a... 2000-07-14 12:46:30 UTC Re: RE Missing Posts [#4336868] drspiff@t... 2000-07-14 15:41:43 UTC RE Missing Posts A missing but traceable post A. G. Eckstein 2000-07-14 16:22:36 UTC Re: [CAD_CAM_EDM_DRO] RE Missing Posts A missing but traceable post William Scalione 2000-07-14 20:01:33 UTC Re: [CAD_CAM_EDM_DRO] RE Missing Posts A missing but traceable post Stan Stocker 2000-07-14 23:06:55 UTC Re: [CAD_CAM_EDM_DRO] RE Missing Posts A missing but traceable post Darrell 2000-07-14 23:20:15 UTC Re: [CAD_CAM_EDM_DRO] RE Missing Posts A missing but traceable post