CAD CAM EDM DRO - Yahoo Group Archive

Re: Toothed belt drives and pulleys

Posted by Polaraligned
on 2007-03-06 14:17:58 UTC
I purchase my belts and pulleys from stock drive products:
http://www.sdp-si.com/
I used the GT2 for my Bridgeport. HTD is pretty popular.
I don't think you will need anything that big if your lathe is
4-1/2". They have a very helpful pulley centers calculator
on the website.


Scott


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "zs6bxi" <bobt@...> wrote:
>
> Hi to the group.
>
> I am looking at motorising the lead screw of my boxford lathe
> ( 4 1/2inch )with a stepper motor. Can anyone point me in the correct
> direction for a site that discribes toothed belt pulley manufacture ?
>
> Regards Bob
>

Discussion Thread

zs6bxi 2007-03-06 14:02:27 UTC Toothed belt drives and pulleys Polaraligned 2007-03-06 14:17:58 UTC Re: Toothed belt drives and pulleys Robert Hedan 2007-03-06 14:22:49 UTC RE : [CAD_CAM_EDM_DRO] Toothed belt drives and pulleys Alan KM6VV 2007-03-06 14:24:32 UTC controler inputs lwgran 2007-03-06 15:14:15 UTC [CAD_CAM_EDM_DRO] controler inputs ballendo 2007-03-06 15:31:13 UTC Re: controller inputs Bob Muse 2007-03-06 15:39:58 UTC Re: [CAD_CAM_EDM_DRO] controler inputs Alan KM6VV 2007-03-06 16:48:54 UTC Re: [CAD_CAM_EDM_DRO] controler inputs Alan KM6VV 2007-03-06 17:07:19 UTC Re: [CAD_CAM_EDM_DRO] Re: controller inputs Alan Rothenbush 2007-03-21 17:53:55 UTC Re: [CAD_CAM_EDM_DRO] Re: controller inputs Mark Vaughan 2007-03-22 01:21:20 UTC RE: [CAD_CAM_EDM_DRO] Re: controller inputs