CAD CAM EDM DRO - Yahoo Group Archive

Re: Clamping Fixture

Posted by Fred Smith
on 2007-03-08 05:50:59 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Victor A. Estes" <vestes@...>
wrote:
>
> Hi, has anyone built a vacuum table for a CNC mill? I need to clamp
some aluminum plates (2 1/2" wide x 3 1/2" long x 1/2" and 1/4" thick)
flat to the milling table so that I can surface the top of the plates.

Victor,

Have you seen this?

http://www.cadcamcadcam.com/index.asp?PageAction=VIEWPROD&ProdID=150

Fred Smith - IMService
THE source for low cost Cad-Cam and desktop CNC
Celebrating 15 years of service.

Discussion Thread

Victor A. Estes 2007-03-07 08:54:35 UTC Clamping Fixture Jon Elson 2007-03-07 09:44:50 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture Victor A. Estes 2007-03-07 11:06:19 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture ballendo 2007-03-07 15:06:59 UTC Re: Clamping Fixture ballendo 2007-03-07 15:16:35 UTC Re: Clamping Fixture Rexarino 2007-03-07 15:46:17 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture David A. Frantz 2007-03-07 18:00:43 UTC Re: [DIY-CNC] Clamping Fixture Victor A. Estes 2007-03-07 19:06:56 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture Tom Hubin 2007-03-07 22:32:02 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture John Dammeyer 2007-03-07 23:02:02 UTC RE: [CAD_CAM_EDM_DRO] Clamping Fixture Fred Smith 2007-03-08 05:50:59 UTC Re: Clamping Fixture Victor A. Estes 2007-03-08 06:33:04 UTC Re: [CAD_CAM_EDM_DRO] Re: Clamping Fixture Victor A. Estes 2007-03-08 06:54:32 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture Tom Hubin 2007-03-08 12:40:55 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture Victor A. Estes 2007-03-08 14:54:43 UTC Re: [CAD_CAM_EDM_DRO] Clamping Fixture