Re: spindle start and stop
Posted by
Terry Ackland
on 2000-07-23 17:55:06 UTC
-Thanks Doug and all,
I suppose you have guessed I am ignorant with electronics? The only
things I have assembled were a couple of Camtronics controllers which
after discovering that half the mosfets were earthed on one board
worked out ok.
Thats about it, besides keeping some tube equipment running, but that
hardly counts, they have components the size of cocktail sausages!
Terry
-- In CAD_CAM_EDM_DRO@egroups.com, "Doug Harrison" <prototype@c...>
wrote:
I suppose you have guessed I am ignorant with electronics? The only
things I have assembled were a couple of Camtronics controllers which
after discovering that half the mosfets were earthed on one board
worked out ok.
Thats about it, besides keeping some tube equipment running, but that
hardly counts, they have components the size of cocktail sausages!
Terry
-- In CAD_CAM_EDM_DRO@egroups.com, "Doug Harrison" <prototype@c...>
wrote:
>the relay.
> My previous post:
> >
> > .... some parallel ports may not source enough current to drive
> Ifparallel
> > you have this problem the easiest solution is to get a different
> > port card. It's not likely a problem.milliamps at
> >
> Terry;
> I just wired up the 2A SSR's I have here. They only draw 2.0
> 4V and 2.8ma at 5V.easily
> You will not have any problems. The wimpiest parallel port can
> provide this.
>
> Good luck;
> Doug
Discussion Thread
Doug Harrison
2000-07-23 16:54:54 UTC
Re: [CAD_CAM_EDM_DRO] Re: spindle start and stop
Doug Harrison
2000-07-23 17:16:15 UTC
Re: [CAD_CAM_EDM_DRO] Re: spindle start and stop
Terry Ackland
2000-07-23 17:55:06 UTC
Re: spindle start and stop
Tim Goldstein
2000-07-25 07:59:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: spindle start and stop
Doug Harrison
2000-07-25 13:35:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: spindle start and stop