Step & Direction for Bridgeport Boss 3/4/5/6
Posted by
Roland Friestad
on 2000-07-26 06:15:16 UTC
To the group -
I'd be glad to hear from any of you guys who have converted Bridgeport CNC
mills to run on step and direction signals using the existing Bridgeport
drivers - Either on or off list -
I"ve been fooling with these things for a long time now but have always just
removed the whole Bridgeport control and replaced it with a new one so I've
never taken the time to go at it this way - If those of you who have would
share the info it would be appreciated -
Related to that - I've got lots of Bridgeport circuit boards, transformers,
complete controls, etc, etc, that could be used to work out some sort of a
trade for assistance - Besides, I need to clean out the shop again and hate
to just scrap out this stuff -
Roland
I'd be glad to hear from any of you guys who have converted Bridgeport CNC
mills to run on step and direction signals using the existing Bridgeport
drivers - Either on or off list -
I"ve been fooling with these things for a long time now but have always just
removed the whole Bridgeport control and replaced it with a new one so I've
never taken the time to go at it this way - If those of you who have would
share the info it would be appreciated -
Related to that - I've got lots of Bridgeport circuit boards, transformers,
complete controls, etc, etc, that could be used to work out some sort of a
trade for assistance - Besides, I need to clean out the shop again and hate
to just scrap out this stuff -
Roland