CAD CAM EDM DRO - Yahoo Group Archive

Re: 3D printer progress

on 2007-05-23 05:59:57 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ballendo" <ballendo@...> wrote:
>
> Graham,
>
> Would it work as-is if you had more gantry travel?
>

Thinking about it further I think the answer is no because the
actually paper feed burst is quite short and I suspect the gantry
would be miles away from the "paper". Otherwise it would detect paper
before it was supposed to and complain. Looking back it was stupid of
me not to record the movements before concluding it didn't move much
because JUST two roller rotations is JUST 4"!

Graham

Discussion Thread

Graham Stabler 2007-05-16 16:04:10 UTC 3D printer progress vrsculptor 2007-05-16 18:55:48 UTC Re: 3D printer progress Graham Stabler 2007-05-17 01:50:30 UTC Re: 3D printer progress Graham Stabler 2007-05-20 08:24:38 UTC Re: 3D printer progress dandumit 2007-05-22 04:22:23 UTC Re: 3D printer progress Graham Stabler 2007-05-22 06:03:23 UTC Re: 3D printer progress ballendo 2007-05-22 23:46:56 UTC Re: 3D printer progress Graham Stabler 2007-05-23 04:01:41 UTC Re: 3D printer progress Graham Stabler 2007-05-23 05:59:57 UTC Re: 3D printer progress ballendo 2007-05-24 03:32:36 UTC Re: 3D printer progress Graham Stabler 2007-05-24 04:09:53 UTC Re: 3D printer progress al5502 2007-05-24 09:20:56 UTC Re: 3D printer progress Graham Stabler 2007-05-24 11:06:12 UTC Re: 3D printer progress al5502 2007-05-25 08:05:40 UTC Re: 3D printer progress Graham Stabler 2007-05-25 10:15:09 UTC Re: 3D printer progress