3D printer, first 2D prints
Posted by
Graham Stabler
on 2007-05-26 13:41:30 UTC
Well I have it working, I can successfully print images on a flat
surface its not completely sorted yet but its very encouraging, I'll
try and post some files later in the weekend of it operating and the
results.
I don't have my belt drive but I found that one of the rollers in the
printer could be pulled off its shaft and pushed on the stepper shaft,
I then just make the cable drive up as before, a belt will be better
but its a bank holiday and it would be a shame to waste the time.
Graham
surface its not completely sorted yet but its very encouraging, I'll
try and post some files later in the weekend of it operating and the
results.
I don't have my belt drive but I found that one of the rollers in the
printer could be pulled off its shaft and pushed on the stepper shaft,
I then just make the cable drive up as before, a belt will be better
but its a bank holiday and it would be a shame to waste the time.
Graham
Discussion Thread
Graham Stabler
2007-05-26 13:41:30 UTC
3D printer, first 2D prints
Graham Stabler
2007-05-26 16:40:09 UTC
Re: 3D printer, first 2D prints
James Cullins
2007-05-26 16:49:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: 3D printer, first 2D prints
Graham Stabler
2007-05-26 17:45:26 UTC
Re: 3D printer, first 2D prints
JCullins
2007-05-26 18:13:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: 3D printer, first 2D prints
Graham Stabler
2007-05-26 19:00:09 UTC
Re: 3D printer, first 2D prints
BRIAN FOLEY
2007-05-26 20:25:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: 3D printer, first 2D prints
dandumit
2007-05-27 04:29:10 UTC
Re: 3D printer, first 2D prints
Graham Stabler
2007-05-27 05:34:46 UTC
Re: 3D printer, first 2D prints