Re: [CAD_CAM_EDM_DRO] 3d printer binder supply
Posted by
Abby Katt
on 2007-05-31 14:41:36 UTC
Graham, Hi
hole at the bottom, you pour a known amount of liquid into the container
(the container usually has a fine mark, or is small enough you fill it
to the brim) and then just use a timer/stopwatch to determine how long
it takes for all the liquid to pour out. The hole needs to be smooth,
you can't just puncture a hole in some plastic.
A client of mine (years ago) did this, under-pressure, to check the
consitency of their brand of dog-food (to see how hard poochy had to
strain. :P) Seriously. It was actually part of their marketting at the
time...
Good luck!
Abby
(http://www.silverkatt.co.uk)
[Non-text portions of this message have been removed]
> Also does anyone know a simple way to measure viscosity, I don't knowThe simplest way to measure viscosity is to use a container with a small
> what I am going to try feeding into the cartridge but I'd like it to
> seem as much like ink as possible, I'm fairly sure water like
> substances just drip out of the nozzles.
>
hole at the bottom, you pour a known amount of liquid into the container
(the container usually has a fine mark, or is small enough you fill it
to the brim) and then just use a timer/stopwatch to determine how long
it takes for all the liquid to pour out. The hole needs to be smooth,
you can't just puncture a hole in some plastic.
A client of mine (years ago) did this, under-pressure, to check the
consitency of their brand of dog-food (to see how hard poochy had to
strain. :P) Seriously. It was actually part of their marketting at the
time...
Good luck!
Abby
(http://www.silverkatt.co.uk)
[Non-text portions of this message have been removed]
Discussion Thread
Graham Stabler
2007-05-31 12:31:42 UTC
3d printer binder supply
Abby Katt
2007-05-31 14:41:36 UTC
Re: [CAD_CAM_EDM_DRO] 3d printer binder supply
Bob Headrick
2007-05-31 22:27:42 UTC
Re: [CAD_CAM_EDM_DRO] 3d printer binder supply
Chris Cain
2007-06-01 02:11:24 UTC
RE: [CAD_CAM_EDM_DRO] 3d printer binder supply
Graham Stabler
2007-06-01 02:18:06 UTC
Re: 3d printer binder supply
G L Travis
2007-06-01 05:44:50 UTC
Re: 3d printer binder supply