My new cnc router /plasma cuuter video

Here is a video of my nearly finished cnc router/plasma cutter.
http://video.google.com/videoplay?docid=5437907076855559029

I have a bit more to do in that I have to build the plasma cutter torch holder and make the clips to hold the metal from the bottom. I need to make the vertical stand parts also.
The idea of my machine was to build a simple cnc router that I could roll around my shop and when not using it store it vertically and out of the way.
I'm using a rack and pinion drive with 2 452 oz in bipolar parallel wired motors driving the Y axis. The right hand motor is slaved to the other motor using Mach3 software. I'm using the Gecko G203 step motor drivers. I just finished routing a new address sign for my house with this machine. I'll soon post a short video of it running.
I live about 1/3 of a mile from the Woodinville McLendon's. God Bless McLendon ! While I built this mostly from parts I already had, it seemed like I was running down to Mclendos every time I worked on the machine to get a fasterner or something. They always had what I needed whether it was metric or imperial.

Dan Mauch
www.camtronics-cnc.com
www.seanet.com/~dmauch

Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch

----- Original Message -----
From: shadi_salhab_78
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Sunday, June 03, 2007 9:52 PM
Subject: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.



Hi All,

I've got this Fanuc yellow cap 20M (23Nm TRQ, 18 Amp, 213V 1500RPM)
DC brush motor . I'm driving it with onther brand drive (Rutex R2020)
never burning the 10 amp fuse !

Is there any way I can drive it by the G320?
Thanks,
Shadi Salhab

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Bob Campbell" <bob@...> wrote:
>
> Shadi,
>
> Mariss is very good about answering email. Just be patient as he is
very busy.
>
> You can also ask the group about your motor.
>
> Robert Colin Campbell
> Bob Campbell Designs
> www.Campbelldesigns.net
> Mach 2/3 breakout boards
> Relay boards
> Spindle Speed boards
> Stepper motors
> Plasma Torch Height control
> ----- Original Message -----
> From: shadi_salhab_78
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Sent: Sunday, June 03, 2007 11:35 AM
> Subject: [CAD_CAM_EDM_DRO] Gecko Support Email
>
>
> Hi all,
> I've send an email to gecko company asking for motor compatibality ,
> but no answer ! Is this always the case ? How can contact them ?
> Thanks,
> Shadi Salhab
>
>
>
>
>
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]