Re: [CAD_CAM_EDM_DRO] Re: Gecko Support / Motor Spec.

Shadi,

You can, if you can live with 6-700 RPM in your application. Voltage dictates the speed. Current dictates the torque. The Gecko can handle 20 amps. So you'd be ok on torque. Just much slower top speed at 80 volts.

Thats the trouble with all those Fanuc motors, the voltage is always so high.

Plated amps on a servo is what it will draw when applying it's max continuous torque. under light loads it probably never draws over 4 or 5 amps at 213v.

Ron

shadi_salhab_78 <salhab@...> wrote:

Hi All,

I've got this Fanuc yellow cap 20M (23Nm TRQ, 18 Amp, 213V 1500RPM)
DC brush motor . I'm driving it with onther brand drive (Rutex R2020)
never burning the 10 amp fuse !

Is there any way I can drive it by the G320?
Thanks,
Shadi Salhab

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Bob Campbell" <bob@...> wrote:
>
> Shadi,
>
> Mariss is very good about answering email. Just be patient as he is
very busy.
>
> You can also ask the group about your motor.
>
> Robert Colin Campbell
> Bob Campbell Designs
> www.Campbelldesigns.net
> Mach 2/3 breakout boards
> Relay boards
> Spindle Speed boards
> Stepper motors
> Plasma Torch Height control
> ----- Original Message -----
> From: shadi_salhab_78
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Sent: Sunday, June 03, 2007 11:35 AM
> Subject: [CAD_CAM_EDM_DRO] Gecko Support Email
>
>
> Hi all,
> I've send an email to gecko company asking for motor compatibality ,
> but no answer ! Is this always the case ? How can contact them ?
> Thanks,
> Shadi Salhab
>
>
>
>
>
> [Non-text portions of this message have been removed]
>






[Non-text portions of this message have been removed]