Re: [CAD_CAM_EDM_DRO] Re: USB controls 4 steppers

There's already a serial port-based controller that can be driven
from a USB port - its called DeskCNC.

Regards,
Tony

At 13:46 10/08/2007, you wrote:

>--- In CAD_CAM_EDM_DRO@yahoogroups.com, Mike Pogue <mpogue@...> wrote:
> >
> > I have done something very similar, using the same USB-to-FIFO
>converter
> > in "bit bang" mode, but connected to a HobbyCNC board. It works pretty
> > well.
> >
>Mike, I'm trying to build an usb output board for Mach3.
>What software did you used to drive you're steppers ?
>Can you share the solution ?
>
>Daniel
>
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List
>owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
>timg@...
>Moderator: pentam@... indigo_red@...
>davemucha@... [Moderators]
>URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
>OFF Topic POSTS: General Machining
>If you wish to post on unlimited OT subjects
>goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com
>to reach it if you have trouble.
>http://www.metalworking.com/news_servers.html
>
>http://groups.yahoo.com/group/jobshophomeshop I consider this to
>be a sister site to the CCED group, as many of the same members are
>there, for OT subjects, that are not allowed on the CCED list.
>
>NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING
>THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
>bill
>List Mom
>List Owner
>
>
>Yahoo! Groups Links
>
>
>