CAD CAM EDM DRO - Yahoo Group Archive

USB controls 4 steppers

Posted by Bill Vance
on 2007-08-09 18:08:45 UTC
Hi gang;

Something of possible interest:

The current issue of Electronic Design, in the, "Ideas For Design",
section, (P51), there is an article about how to control 4 stepper moters off
the USB port. If you don't get the mag, you can go to:

http://www.electronicdesign.com

It uses a USB-to-FIFO parallel interface module, (DLP-USB245M), chip, and you
can check that out at:

http://www.dlpdesign.com

Bill


--
********************************************************************************
* *
RKBA! * Blessings on thee, oh Israel!!! * 4-19!
* *
********************************************************************************

An _EFFECTIVE_ | Insured by | All Matter is vibration. | Let he who hath no
weapon in every | by Colt; | --Max Planck | weapon, sell his
hand = Freedom | Dial | In the beginning was the | garment, and buy a
on every side!! | 1-911-A1 | Word. --The Holy Bible | sword. --Jesus Christ

********************************************************************************

Constitutional Government is dead! LONG LIVE THE CONSTITUTION!!!!!!

********************************************************************************

Discussion Thread

Bill Vance 2007-08-09 18:08:45 UTC USB controls 4 steppers Mike Pogue 2007-08-09 22:58:46 UTC Re: [CAD_CAM_EDM_DRO] USB controls 4 steppers dandumit 2007-08-10 05:52:17 UTC Re: USB controls 4 steppers Tony Jeffree 2007-08-10 10:03:40 UTC Re: [CAD_CAM_EDM_DRO] Re: USB controls 4 steppers Mike Pogue 2007-08-10 11:23:48 UTC Re: [CAD_CAM_EDM_DRO] Re: USB controls 4 steppers dandumit 2007-08-13 06:05:43 UTC Re: USB controls 4 steppers Mike Pogue 2007-08-13 19:31:49 UTC Re: [CAD_CAM_EDM_DRO] Re: USB controls 4 steppers