Home switch wiring problem / Help Please

Hi Guys,

I have a home switch with 3 wires, wire 1 is +5V, Wire2 is 0V and wire3 is output

I connected wire 1 to +5V and wire2 to GND and wire3 to input pin10 in the breakout board, and of course setup Mach3 X++ X-- and home to 10

when I trigger the switch nothing happen, it seems it is not sending a signal to Mach3.

if you have an idea how it should be wired please advice

Seiman


---------------------------------
Ask a question on any topic and get answers from real people. Go to Yahoo! Answers.

[Non-text portions of this message have been removed]