Re: [CAD_CAM_EDM_DRO] "twinned"servos on 1 axis

Usually the factory setting for the Gecko G320's is pretty darn good. If those are the servo amps you are using. I have set up other servo amps and bench setting them ran from really easy to really hard mainly because the documentation didn't make sense.
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch

----- Original Message -----
From: carlcnc
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Wednesday, October 03, 2007 8:30 AM
Subject: [CAD_CAM_EDM_DRO] "twinned"servos on 1 axis


I am close to mounting 2 servos that will drive my large gantry,

I am hoping I can bench tune them before mounting
my theory is that since reflected load at 15:1 reduction should be
negligible,less than 5 in lbs, I might not have to retune once they
are mounted.
any criticism ,suggestions and warnings are appreciated
thanks
Carl






[Non-text portions of this message have been removed]