Re: List question

I checked out the JR Kerr web site. Interesting product. I couldn't quite
understand though, does the pic board handle the input from the encoders or
is that handled by the computer it is attached to?

I was looking at the Grizzly G1004 in the catalog the other day. How long
have you had it? How do you like it? What don't you like about it?

Have you started to convert your machine to NC yet? What are you planning to
use for your servo motors?


Tim
[Denver, CO]

> -----Original Message-----
> From: Andy Olney [mailto:aolney@...]
> Sent: Wednesday, June 16, 1999 9:01 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: Re: [CAD_CAM_EDM_DRO] List question
>
>
> From: "Andy Olney" <aolney@...>
>
> I am very interested in the EMC information here as well as the other
> threads ( encoders, vacuum forming etc. ) and would prefer it remain all
> mashed together.
>
> I have a small Grizzly knee mill (G1004?), and some pic based servo boards
> from www.jrkerr.com that I am intending to use to move my table.
>
> Andy Olney
>
>
> ------------------------------------------------------------------------
> ONElist: where real people with real interests get connected.
> http://www.onelist.com
> Join a new list today!
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for
> the discussion of shop built systems in the above catagories.
> To Unsubscribe:
> http://www.onelist.com/unsubscribe/CAD_CAM_EDM_DRO
> bill, List Manager
>