CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: electrical noise

on 2007-11-11 21:57:58 UTC
At 06:36 AM 11/11/2007, you wrote:
>Still no progress. New powersupply - same problem. Shielded wire and
> grounding one end. The Pixie just shuts off and on with a jolt. Now
>I could not even run the machine as the problem has worsened by later
>in the day yesterday. At this point I feel totally defeated...


Is there anywhere you can put a car battery and a 7805 with a few caps?

If you suspect the power supply and/or grounding, putting it on a
battery supply with a single point ground may shed light on the problem.



David G. LeVine
Nashua, NH 03060

Discussion Thread

toolspindoctor 2007-11-10 08:08:37 UTC electrical noise caudlet 2007-11-10 08:53:52 UTC Re: electrical noise toolspindoctor 2007-11-10 13:01:50 UTC Re: electrical noise Bill Vance 2007-11-11 01:22:22 UTC Re: [CAD_CAM_EDM_DRO] electrical noise toolspindoctor 2007-11-11 03:36:39 UTC Re: electrical noise toolspindoctor 2007-11-11 12:02:52 UTC Re: electrical noise David G. LeVine 2007-11-11 21:57:58 UTC Re: [CAD_CAM_EDM_DRO] Re: electrical noise Arturo E. Duncan 2007-11-12 05:32:48 UTC Re: electrical noise