Re: MillShapes

The guy in the picket line says to the other guy, "We're on strike for
shorter hours."

The other guy says, "Yeah, I always did think 60 minutes was too long."
--
Phil Mattison
http://www.ohmikron.com/
Motors::Drivers::Controllers::Software

----- Original Message -----
From: Graham Stabler <grezmos@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, December 07, 2007 1:13 PM
Subject: [CAD_CAM_EDM_DRO] Re: MillShapes


> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "stcnc2000" <stcnc@...> wrote:
> > > Sorry, I pulled the Millshapes Demo, because of problems with the
> > time limiting software.
>
> Good, my time is limited enough without special software to do it :)
>