Re: [CAD_CAM_EDM_DRO] Doubling up servo's...

Ya, they are MCG 33xxx motors, both new... and I was thinking a Rutex 2020 drive..
the motors are 90vdc unit's w/ a current rating of about 30 amps [memory]
I think it should work.. just wondered if anyone else has ever done it..

Jarrett

----- Original Message -----
From: Leslie Newell <lesnewell@...>
Date: Saturday, December 8, 2007 11:34 am
Subject: Re: [CAD_CAM_EDM_DRO] Doubling up servo's...

> As long as the motors are both the same it shouldn't be a problem. If
> the motors are low current (say a peak current of less than 75% of the
> drive's maximum output) then run them in parallel otherwise run
> them in
> series.
>
> Les
>
> jerryflyguy wrote:
> > Curious.. has anyone ever doubled up or stacked servo's. I was
> planning
> > on using two on a common drive timing belt [one belt, two
> servo's and a
> > pulley which they both drive]. Only one of the two would have a
> encoder
> > and the power leads from both of them would be wired to the same
> > drive.. [I'm not sure if they should be parralleled or series..]
> >
> > Curious...
> >
> > Jarrett Johnson
> >
> >
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@..., timg@...
> Moderator: pentam@... indigo_red@...
> davemucha@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru Google.com to
> reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to
> be a sister site to the CCED group, as many of the same members
> are there, for OT subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING
> THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>