Re: [CAD_CAM_EDM_DRO] Rotary indexer drive
Posted by
Bob Muse
on 2008-01-25 00:21:47 UTC
Hi Bob
You might want to take a look at CNCPRO. Much less complex than Mach3, free online and will do that job.
You might want to take a look at CNCPRO. Much less complex than Mach3, free online and will do that job.
----- Original Message -----
From: zs6bxi
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Thursday, January 24, 2008 11:36 PM
Subject: [CAD_CAM_EDM_DRO] Rotary indexer drive
Hi all,
Having been lurking on this group for a while I am now at the
point of needing advice.
I want to cut a 127 tooth gear. I have the dividing equip with a 72
teeth worm wheel setup. I have a suitable stepper motor with a gecko
drive for it and I have an 'old' 1Gig laptop with parallel and serial
port. I'm an electrical engineer so playing interfaces is no problem.
What I'm looking for is advice on what software to get to drive the
stepper motor. I've looked at the Mach3 and I think that this could be
made to do the job. But I think that this would be total overkill for
what I want to do. Is there not something out there ( preferably
shareware or something). I don't mind paying the 160 dollars or so but
for what is basically a one off job this is a bit much.
Regards Bob
[Non-text portions of this message have been removed]
Discussion Thread
zs6bxi
2008-01-24 23:36:22 UTC
Rotary indexer drive
Stephen Wille Padnos
2008-01-24 23:40:51 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer drive
hannu
2008-01-25 00:05:01 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer drive
Tony Jeffree
2008-01-25 00:08:26 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer drive
Bob Muse
2008-01-25 00:21:47 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer drive
Paul Kelly
2008-01-25 00:35:44 UTC
RE: [CAD_CAM_EDM_DRO] Rotary indexer drive
roboticscnc
2008-01-25 02:19:56 UTC
Rotary indexer - Lathe Tool Changer
Ron Ginger
2008-01-25 06:04:51 UTC
Re: Rotary indexer - Lathe Tool Changer
wotisname
2008-01-25 09:58:40 UTC
Re: Rotary indexer drive
Bob Muse
2008-01-25 12:09:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: Rotary indexer drive
David A. Frantz
2008-01-26 14:07:48 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer - Lathe Tool Changer
hannu
2008-01-26 14:33:59 UTC
Re: [CAD_CAM_EDM_DRO] Rotary indexer - Lathe Tool Changer
januseng
2008-01-26 16:17:56 UTC
Re: Rotary indexer - Lathe Tool Changer
John Mesh
2008-02-02 20:40:48 UTC
Re: Rotary indexer drive