Re: [CAD_CAM_EDM_DRO] Re: Stepper Size Selection
Posted by
Steve Blackmore
on 2008-06-15 01:36:09 UTC
On Sat, 14 Jun 2008 21:13:13 -0700, you wrote:
ballscrews is capable of 5m/min without loosing steps or stalling, but
it's tuned down to 3m/min (120 ipm) which seems a more sensible speed
for a small machine. Chinese Leadshine drives at 50VDC @ 4A
Spindle motor's been replaced with a 180V DC 2Kw motor, 0-3200 rpm.
It's reliably taking .2" deep cuts with a 1/2 inch two flute slot drill
at 20 ipm and 3000 rpm in 2017 Aluminium.
Steve Blackmore
--
>> I was coming to that conclusion. Problem is my mill doesn't seem to beSX3 conversion here with 340 oz/in motors direct coupled to 4mm pitch
>> all that common (which is a pity because it beats any X2 I've seen head
>> and shoulders for quality). It does approximate an X3 so that might be a
>> guide.
ballscrews is capable of 5m/min without loosing steps or stalling, but
it's tuned down to 3m/min (120 ipm) which seems a more sensible speed
for a small machine. Chinese Leadshine drives at 50VDC @ 4A
Spindle motor's been replaced with a 180V DC 2Kw motor, 0-3200 rpm.
It's reliably taking .2" deep cuts with a 1/2 inch two flute slot drill
at 20 ipm and 3000 rpm in 2017 Aluminium.
Steve Blackmore
--
Discussion Thread
dnaman43
2008-06-14 09:41:28 UTC
Stepper Size Selection
turbulatordude
2008-06-14 14:47:49 UTC
Re: Stepper Size Selection
dnaman43
2008-06-14 15:12:02 UTC
Re: Stepper Size Selection
caudlet
2008-06-14 15:36:14 UTC
Re: Stepper Size Selection
dnaman43
2008-06-14 21:04:13 UTC
Re: Stepper Size Selection
Michael Fagan
2008-06-14 21:13:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper Size Selection
Steve Blackmore
2008-06-15 01:36:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper Size Selection
dnaman43
2008-06-15 09:40:07 UTC
Re: Stepper Size Selection
dnaman43
2008-06-15 09:40:15 UTC
Re: Stepper Size Selection
Michael Fagan
2008-06-15 10:31:45 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper Size Selection
skullworks
2008-06-15 11:13:32 UTC
Re: Stepper Size Selection
David G. LeVine
2008-06-15 14:28:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper Size Selection
dnaman43
2008-06-15 14:42:49 UTC
Re: Stepper Size Selection