CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Polished acrylic machining

on 2008-10-14 14:38:16 UTC
Hi Danny,

depends on the shape- if its a flat area you can get good results simply by lacquering the parts this hides the m/c'ng defects. I have used this technique to produce good optical clarity on prototypes with little need for excessive polishing.


Nev



----- Original Message ----
From: Danny Miller <dannym@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Tuesday, 14 October, 2008 10:32:51 PM
Subject: [CAD_CAM_EDM_DRO] Polished acrylic machining


Let's say I wanted to do some Taig CNC milling on an acrylic or
polycarbonate block. The result needs to have some decent optical
clarity but I expect the tooling will result in a fairly scratched,
milky surface.

Is there any simple answer for this? I know there are plastic polishes
that can kinda buff that out but I'd expect major problems getting a
Dremel buffer wheel into small low spots. Is there any magic cutting
head or something that results in a smooth surface, or some special tool
or chemical for removing them?

Thanks


[Non-text portions of this message have been removed]

Discussion Thread

you get one guess 2008-01-31 22:29:07 UTC CAM to CNC interface? Michael Fagan 2008-01-31 22:46:21 UTC Re: [CAD_CAM_EDM_DRO] CAM to CNC interface? hannu 2008-01-31 23:54:54 UTC Re: [CAD_CAM_EDM_DRO] CAM to CNC interface? stan 2008-02-01 04:20:41 UTC Re: [CAD_CAM_EDM_DRO] CAM to CNC interface? Jon Elson 2008-02-01 11:58:36 UTC Re: [CAD_CAM_EDM_DRO] CAM to CNC interface? Danny Miller 2008-10-14 14:32:55 UTC Polished acrylic machining NEVILLE WEBSTER 2008-10-14 14:38:16 UTC Re: [CAD_CAM_EDM_DRO] Polished acrylic machining aclausing2003 2008-10-14 15:33:04 UTC Re: Polished acrylic machining kefale1 2008-10-15 07:53:37 UTC Re: Polished acrylic machining Danny Miller 2008-10-15 09:56:35 UTC Re: [CAD_CAM_EDM_DRO] Re: Polished acrylic machining caudlet 2008-10-15 10:49:45 UTC Re: Polished acrylic machining - OFF TOPIC Mark Hubrich 2008-10-22 16:55:58 UTC RE: [CAD_CAM_EDM_DRO] Re: Polished acrylic machining