Re: [CAD_CAM_EDM_DRO] Metric bore timing pulley
Posted by
Nigel F Misso
on 2008-12-17 00:14:12 UTC
Hi Alan;
Could you change the other end and use a MXL timing belt?
https://sdp-si.com/eStore/Direct.asp?GroupID=346
Nigel F Misso, PE
http://www.linkedin.com/in/nigelmisso
Could you change the other end and use a MXL timing belt?
https://sdp-si.com/eStore/Direct.asp?GroupID=346
Nigel F Misso, PE
http://www.linkedin.com/in/nigelmisso
----- Original Message -----
From: Alan Rothenbush
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Tuesday, December 16, 2008 7:22 PM
Subject: [CAD_CAM_EDM_DRO] Metric bore timing pulley
I need an XL timing pulley with a 5mm bore and I can't seem to find one.
I _could_ maybe machine up a 5mm to .25" sleeve but I'm not quite sure what I'd use for a boring tool; I have nothing nearly that small.
Any ideas ?
Alan
[Non-text portions of this message have been removed]
Discussion Thread
Alan Rothenbush
2008-12-16 19:23:00 UTC
Metric bore timing pulley
Jon Elson
2008-12-16 20:50:21 UTC
Re: [CAD_CAM_EDM_DRO] Metric bore timing pulley
Nigel F Misso
2008-12-17 00:14:12 UTC
Re: [CAD_CAM_EDM_DRO] Metric bore timing pulley
Paul Kelly
2008-12-17 02:14:33 UTC
RE: [CAD_CAM_EDM_DRO] Metric bore timing pulley
danmauch
2008-12-17 05:42:41 UTC
Re: Metric bore timing pulley
Marv Frankel
2008-12-17 06:29:19 UTC
Re: Metric bore timing pulley
Alan Marconett
2008-12-17 10:07:20 UTC
RE: [CAD_CAM_EDM_DRO] Re: Metric bore timing pulley
Bob Butcher
2008-12-19 18:03:38 UTC
Re: Metric bore timing pulley
Alan Rothenbush
2009-01-12 17:14:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: Metric bore timing pulley