CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Re: Metric bore timing pulley

on 2008-12-17 10:07:20 UTC
Alan,

If you have a 3/8" boring bar holder, then Sherline sells small boring bars,
I just bored out a 6mm gear to .25".

Alan KM6VV

-----Original Message-----
On Behalf Of Marv Frankel

Alan,
You might try sdp-si.com. They have almost every size timing
pulley known to man. If you lived in my neighborhood, I'd bore it for
you. I have a set of 5mm-6mm carbide boring bars. I seldom use them,
but when you need to bore those tiny sizes, they sure come in handy.

Marv Frankel
Los Angeles

Discussion Thread

Alan Rothenbush 2008-12-16 19:23:00 UTC Metric bore timing pulley Jon Elson 2008-12-16 20:50:21 UTC Re: [CAD_CAM_EDM_DRO] Metric bore timing pulley Nigel F Misso 2008-12-17 00:14:12 UTC Re: [CAD_CAM_EDM_DRO] Metric bore timing pulley Paul Kelly 2008-12-17 02:14:33 UTC RE: [CAD_CAM_EDM_DRO] Metric bore timing pulley danmauch 2008-12-17 05:42:41 UTC Re: Metric bore timing pulley Marv Frankel 2008-12-17 06:29:19 UTC Re: Metric bore timing pulley Alan Marconett 2008-12-17 10:07:20 UTC RE: [CAD_CAM_EDM_DRO] Re: Metric bore timing pulley Bob Butcher 2008-12-19 18:03:38 UTC Re: Metric bore timing pulley Alan Rothenbush 2009-01-12 17:14:57 UTC RE: [CAD_CAM_EDM_DRO] Re: Metric bore timing pulley