Newbie has alot of questions.....
Posted by
dmickey0576
on 2009-02-21 19:56:18 UTC
I'm planning on building a 3axis and then a 5axis gantry style router.
I program NC's for a living.
I'll be cutting wood, plastic, foam, composites, light aluminum.
I want to make a 'database' of rails, 80/20 or rexroth extrusions,
gearing, belts/gears, ets.
I'm really week on the electrical side of things and would like
suggestions on where I could start and the where to go from there.
Any advise is really appreciated.
ALSO....getting around the postings here seems a little cumbersome.
Is there a trick to doing searches that most new folks dont know
about and such?
Again...thanks for any help.
Dan
I program NC's for a living.
I'll be cutting wood, plastic, foam, composites, light aluminum.
I want to make a 'database' of rails, 80/20 or rexroth extrusions,
gearing, belts/gears, ets.
I'm really week on the electrical side of things and would like
suggestions on where I could start and the where to go from there.
Any advise is really appreciated.
ALSO....getting around the postings here seems a little cumbersome.
Is there a trick to doing searches that most new folks dont know
about and such?
Again...thanks for any help.
Dan
Discussion Thread
dmickey0576
2009-02-21 19:56:18 UTC
Newbie has alot of questions.....
danmauch
2009-02-22 08:13:07 UTC
Re: Newbie has alot of questions.....
gcode fi (hanermo)
2009-02-22 11:29:44 UTC
Re: [CAD_CAM_EDM_DRO] Newbie has alot of questions.....
Russell Dunn
2009-02-23 03:01:03 UTC
Re: Newbie has alot of questions.....
James Stein
2009-02-24 14:16:49 UTC
Re: Newbie has alot of questions.....